16" - 4.5' Draft (daggerboard depth is controlled from the cockpit and the rudders kick up)
5750# Estimated Weight (with all accessories: outboard, ground tackle, topped off tanks, et cetera)
Hulls are hand laid fiberglass from female molds. Round bilge configuration. Very well done with no apparent voids and no blisters. Many thoughtful touches built into the design. Much emphasis is placed on easy short-handed operation while underway.
Rigging
42' Aluminum masthead rig with a little pre-bend and Tides Marine Sailtrack System
13' Z-spar boom rigged with topping lift halyard, 12:1 outhaul, and two reefing lines
Standing rigging - almost all new - includes cap shrouds, fore and aft lowers, forestay and diamond on spreaders
Sta-loks throughout at deck level
Running Rigging - almost all new
2 jib halyards
Also rigged for a spinnaker but no kite is included
Masthead and steaming lights with new (tinned) wire.
Sail Plan
500 s.f. Sail Area
310 s.f. Full Battened High Roach Mainsail - v. good condition
190 s.f. Self-tacking Jib ( about 100%) - fair condition
2 Self-tailing 2 speed jib winches
Adjustable Double Jib Fairleads on 6' tracks
2 single speed winches on mast, one of which is also self-tailing
Mack Pack (or similar) lazy bag with lazy jacks
Auxillary Propulsion
2003 9.9 HP Yamaha Hi Thrust Extra-long shaft Outboard - starts easily and runs well
Achieves 7 Knots WOT
Electrical
Two deep cycle batteries maintained by a
20 Watt Solar Panel
10 Amp charging capability from the Yamaha outboard
Navico Tiller Pilot
Pump for deck washing is fitted and wires run but not yet connected
Care was taken to assemble the various circuits but not likely executed to an ABYC standard
All wiring is tinned, of appropriate gauge, and everything works well.