Great single handing boat if that's what you're looking for
Bottom was stripped to fiberglass in 2006, painted with 3 coats of Interlux 2000E epoxy barrier coat, then VC17. At the same time, the keel was removed, sandblasted, faired, and similarly painted.
Bottom has fresh VC17 (painted April 2016), however, it was painted on the trailer so there are spots I didn't hit (under bunks, parts of keel, keel trunk).
The good news is I have an unopened can of VC17 for the buyer to finish the job with the boat lifted off the trailer.
Equipment:
2010 Tohatsu 5HP 4-stroke long shaft motor with external fuel tank (Model MFS5BL)
Raymarine Tiller Pilot (autopilot)
SCHAEFER Snapfurl roller furler (new in 2006)
New forestay in 2006
Mainsheet replaced in 2007
Halyards replaced in 2008
Traveler and traveler bar replaced in 2011
Cabin pop top
All electrical lights and systems work - battery new in 2014
Cabella 6A battery charger/maintainer new in 2014
Interior cushions and upholstery in excellent condition
Removable dinette table (converts into bed)
Carpeted cabin
Bulkhead mounted Suunto Compass and inclinometer
Port-a-Potty
Sails in excellent condition:
Ullman Full Batten Offshore Mainsail with single reef (new in 2006, reconditioned by Sail Care in 2010 & 2014)
135% Ullman offshore furling headsail (new in 2006, reconditioned by Sail Care in 2010 & 2014)
Both with sail bags
Trailer:
Tongue extension
New tires in 2009 (less than 200 miles on them)
Bearings repacked and new seals in 2005
Bearing Buddies installed
Wiring works but showing signs of age and I would consider rewiring
Additional equipment:
Swim ladder
Lifelines
Topping lift
Davis Windex
Eagle 242 fish finder (used for depth sounding)
Down-the-Hatch front hatch ventilator
Sail cover & tiller cover (New in 2010)
Fenders (x3)
AM/FM/CD receiver with speakers mounted such that it slides into where the hatch covers go. Speakers may need to be replaced as they were left in the boat one winter and the mud dobbers got to them.
Boat, trailer, sails and equipment: $6,000
Optional: I built boat stands in 2006 to do the bottom work mentioned previously. With those and a hydraulic engine hoist I have a method to put the boat in "dry dock" on my driveway. I have done this several times over the years and it can be done singlehandedly. If interested, I'll entertain a reasonable offer for those stands and the engine hoist.
